Product Description
FM or AM processing on demand is standard. Simultaneous FM+AM if programming is 100% simulcast and at same transmitter site. Studio output with very low latency for talent monitoring is also standard. Optional HD-1, HD-2, HD-3 processing and streaming/encoding, RDS. Dual path model available for two separate program feeds broadcasting on FM+FM, FM+AM or FM+FM+AM simulcast with HD output, IP-Streaming with separate processing and encoding and low latency studio processing, all built-in for both feeds.
Additional Information
Frequency Response | +/-0.5dB 20Hz to 15kHz, 17.5kHz in extended mode |
---|---|
Signal to Noise Ratio | Greater than -80dBu de-emphasized, 20Hz to 15kHz |
System Distortion | Less than 0.01% THD below pre-emphasis, inaudible above |
Stereo Separation | 65dB minimum, 20Hz to 15kHz, 70dB typical |
Digital Output Level | Adjustable from -24.0dBFS to 0.0dBFS in 0.1dB increments |
Stereo Baseband Output | Adjustable from -2dBU to +22dBU (0.1dB increments) into 600-Ohms, 20-Ohm output impedance |
A/D Conversion | Crystal Semiconductor CS5361, 24 bit 128x over-sampled delta sigma converter with linear-phase anti-aliasing filter. |
D/A Conversion | Crystal Semiconductor CS4391, 24-bit, 128x oversampled |
External Sync Input | Per AES11 Digital Audio Reference Signal (DARS), reference for digital output sample rate. Range is 32kHz to 96kHz. |
Analog I/O | Two balanced, EMI filtered XLR connectors |
Stereo Generator Connections | Four 75-Ohm BNC female, two inputs, two outputs |
Digital I/O | AES/EBU via four XLR connectors for Main and Aux Digital programs (two stereo in, two stereo out) |
Ethernet | Shared RJ45 supporting 100 and 1000BASE-T Ethernet connections |
Power Requirements | 100-264 VAC, 47-63Hz autosensing, dual PSU |
Power Connector | Dual IEC male, detachable 3-wire power cords supplied |
Power Supply | Internal dual redundant, hot-swappable |
Environmental | Operating: 0 to 50 degrees C |